February 8, 2007 - Rudder Stops
I had already countersunk all the aft canopy holes; the next step was to
drill them to #19.
February 8, 2007 - Rudder Stops |
||||||
| Lynnette bought me a #35 drill bit at the local hardware store and I used it to drill out the holes on the roll bar. Then I countersunk them to 6-32. | ||||||
|
|
||||||
|
I had already countersunk all the aft canopy holes; the next step was to
drill them to #19.
|
||||||
|
|
||||||
| I saw no reason I couldn't make the final trim on the trailing edge so I taped it up. | ||||||
|
|
||||||
| And then trimmed it with the die grinder. I'm hoping this is the last time I have to cut with the die grinder. It's really a messy job. The plastic "snow" gets all over the place and sticks to everything. After cutting, there was the usual edge smoothing to do. | ||||||
|
|
||||||