May 14, 2007 - Fuel Vent lines
May 14, 2007 - Fuel Vent lines |
||||||
| I resumed work on the fuel vent lines. I started with the top horizontal bends, then worked my way down each side. I put the three Adel Clamps on which was easy since the screw nutplates had been done long ago. I drilled a hole in the top forward gusset for the fourth Adel clamp. I saved the bottom bends for last. I stopped at this point because I hadn't made the vent bulkhead fitting that goes on the fuse floor yet. | ||||||
|
|
||||||