February 3, 2012 - Building the Spar Table Top

I finished the five spar table legs.  I also made the table top frame -- three pieces -- seen below laying on their side.
 
Despite my best efforts, the cross beams were not even with the sides, so I had to go at them with the Planer.  Not a problem.
 
The table top frames are laid end to end, waiting to have the 3/4" plywood top screwed down. 
 
I bought a 4'x8' piece of 3/4" flooring plywood at Home Depot.  I had them cut it into three equal pieces.  Much easier to transport that way!  I screwed the top onto the frame with 2" screws.   
 
Previous
Home
Next